Instruction manual

Fitting the Panel and Fixing the Hood Canopy

Before fixing the Hood Canopy to the Frame:

• Remove the Grease filters from the Hood Canopy;

• Remove any Activated charcoal filters.

• Working from below, fix the Hood canopy to the

Frame provided, using the 4 screws 12f (M6 x 10)

provided.

• Then hook the upper part of the Panel 3, adjusted to

size, to the rubber supports in the upper part and in

the lower part of the Frame.

• Slide the lower part of the Panel 3 until its metal tabs

slot into the slots in the frame;

12f

ELECTRICAL CONNECTION

• Connect the hood to the mains through a two-pole

switch having a contact gap of at least 3 mm.

• Remove the grease filters (see paragraph Mainte-

nance) being sure that the connector of the feeding

cable is correctly inserted in the socket placed on the

side of the fan.