Use And Care Manual

10
Assembly Instructions
3
4
Assembly of oil pan bracket and side beam
As shown in the figure below, install the left and right support and side beam of
the oil pan on the supporting feet and tighten them with M6x12 screws.
B
Hardware Used
M6x12 : x6
Hardware Used
Cylinder anchor bolt : x1
Assembly of cylinder head and bottom plate
1. As shown below, screw the cylinder head rod into the M8 nut on the bottom plate.
2. As shown below, install the cylinder head ring on the cylinder head rod and
tighten it with special screw.
D
H
Cylinder head ring : x1
K
The cylinder push rod : x1
Fig.7
Fig.8
3.集油盘支架、侧横梁的装配
如下图，将集油盘左、右支架和侧横梁安装在支脚上，并用M6x12的螺钉紧固。
4.气瓶顶杆和底板的装配
1、如下图，将气瓶顶杆拧进底板的M8螺母内，
2、如下图，将气瓶顶圈安装在气瓶顶杆上，并用专用螺钉紧固。