Use And Care Manual

12
Assembly Instructions
7
8
Right rear leg assembly
As shown below, insert the frame bar into the mounting hole of the right back leg
and flip the right back leg so that the right back leg is mounted on the oil pan bracket
and side beam, then tighten with the M6x12 screw.
B
Hardware Used
M6x12 : x4
Hardware Used
Assembly of left rear leg
As shown below, install the left rear leg on the oil pan bracket and bottom plate,
then tighten with the M6x12 screw.
B
M6x12 : x3
Fig.11
Fig.12
7.右后支腿的装配
如下图，将车架档杆插入右后支腿的安装孔内，并将右后支腿翻转，使得右后支腿安放在集油盘支架和侧横梁上，然后用M6x12螺钉紧固。
8.左后支腿的装配
如下图，将左后支腿安装在集油盘支架和底板上，然后用M6x12螺钉紧固。
Frame leg
4#
Frame leg
3#