Use And Care Manual

13
Assembly Instructions
9
10
Assembly of rear beams
As shown below, install the two rear beams separately on the rear leg, then tighten
them with the M6x12 screw.
B
Hardware Used
M6x12 : x9
Hardware Used
The assembly of the frame's fastening feet
As shown in the figure below, turn the frame assembly over and attach the frame
mounting feet to the frame supporting legs.
Fig.13
Fig.14
9.后横梁的装配
如下图，将两件后横梁分别安装在后支腿上，然后用M6x12螺钉紧固。
10.车架固定脚的装配
如下图，将车架组件翻转，把车架固定脚安装在车架支腿上。