Use And Care Manual

18
Assembly Instructions
19
20
Assembly of pressure reducing valve hose clamp
As shown below, clamp the pressure reducing valve hose into the pressure
reducing valve hose and tighten the frame leg with M4x12 screws.
E
Hardware Used
M4x12 : x1Screw
Hardware Used
Assembly of oil collecting tray and oil collecting cup
1. As shown in the figure below, install the oil collecting tray on the oil collecting
tray bracket under the furnace body.
2. Install the oil collecting cup on the bracket under the oil collecting tray.
M
Pressure reducing valve
hose clamp : x1
3. Hang the ignition rod at the corresponding position of the oil pan bracket.
Fig.23
Fig.24
3、将点火棒挂着集油盘支架的相应位置上。
2、将集油杯安装在集油盘下方的支架上。
1、如下图，将集油盘安装在炉体下方的集油盘支架上。
19.减压阀软管卡箍的装配
20.集油盘、集油杯的装配
如下图，将减压阀软管卡箍套进减压阀软管，并用M4x12螺钉紧固车架支腿上。
0 degree pressure
reducing valve
90 degree pressure
reducing valve
0 degree pressure reducing valve, 90 degree pressure reducing valve,
the two American pressure reducing valves above are suitable for this product.