Use And Care Manual

Assembly Instructions

Assembly of ﬁre damper, cast iron grill, heat preservation rack and side furnace rack

1. As shown below, open the upper cover of the oven and install the ﬁre damper,

cast iron grill and heat preservation rack in the furnace body in order;

Hardware Used

Cylinder assembly

2. As shown below, open the cover of the side furnace and install the side furnace

rack on the bottom plate of the side furnace;

Place the cylinder in the mounting hole of the chassis plate, tighten the cylinder

stem and ﬁx the cylinder.Your grill is now ready for use.

The cylinder push rod

CHECK FOR SPARKS

After grill assembly is completed,

test Check for sparks when using

the ignition system.

Be sure the GAS IS OFF when you

push the electrical igniter.This will

help assure a trouble-free ignition

when you turn on the gas.

Fig.25

Fig.26

21.挡火板、铸铁烤架、保温架、边炉架的装配

22.气瓶的装配

1、如下图，打开烤炉的上盖，按顺序将挡火板、铸铁烤架、保温架安装在炉体内；

2、如下图，打开边炉盖子，将边炉架安装在边炉底板上；

将气瓶安放在车架底板的安装孔内，并拧紧气瓶顶杆，固定气瓶。

检查是否有火花

烤架装配完成后，在烤架装配完成后进行测试，使用点火系统时进行火花测试。

当你推动电点火器时，一定要把煤气关掉。这将有助于确保在你打开燃气时没有问题的点火。