Use And Care Manual

20
Installation Instructions
For Portable LP-Gas Connection
WARNING:The Type I connective coupling(see Fig.29)supplied with your
grill must not be replaced with a different type of grill/tank connection system.
Removal will result in loss of warranty,gas leakage,fire and severe bodily harm.
The chassis has a cylinder mounting hole which allows the bottom flange of the
20-pound cylinder to be in place (the cylinder is not included).This will help lock
the cylinder.After positioning the cylinder in the cylinder mounting hole of the
chassis plate, tighten the cylinder stem and lock the cylinder (figure 27).
Use only 20-pound cylinders (see LP Gas Safety Requirements for additional
information).As shown in figure 28, if the cylinder is not placed vertically,
the oven is not safe.
Fig.29
Hand Wheel
Type I
Valve
External
Thread
Thermally
Sensitive Nut
Propane
Regulator
The propane tank valve connection supplied with this grill incorporates
four important safe guards:Hand Assembly,Hand Disassembly,Excess
Flow Control and Temperature-Activated Shut-Off.
Fig.27 Fig.28
警告:I型连接联轴器(见图29)
烤架不可更换为不同类型的烤架/槽连接系统。
拆卸将导致保修失效、气体泄漏、火灾和严重的人身伤害。
用于便携式LP-Gas连接
车架底板有一个气瓶安装孔，允许20磅的气瓶底部法兰放置到位(气瓶不包括在内)。
这将有助于锁住气瓶。将气瓶定位在车架底板的气瓶安装孔后，拧紧气瓶顶杆，锁住气瓶(图27)。
只使用20磅的气瓶(详见LP Gas Safety Requirements for additional information)。
如图28所示，如果气瓶不垂直放置，烤炉不安全。
该格栅配置的丙烷罐阀门连接包括四个重要的安全保护装置:手动总成、手动拆卸、过量流量控制和温度启动关闭。