Use And Care Manual

24
OPERATING INSTRUCTIONS
Grill Lighting Instructions
To Light the Main Burners
1 .Make sure the control knobs are in the “OFF” position.
2 .Open the grill hood.
3 .Check the ignition pin position and distance between
the pin and the burner.Refer to Step 18 of the Assembly
Instructions.
4 .Make sure the drip tray is installed.
5 .Open the LPG tank.
6 .Light each burner separately.Turning on two burner
valves together could trip the flow connection (LP grills only).
7 .Push the control knob in and turn the knob to the left to “HIGH” position.Keep
pressing the knob until the burner is lit.
8 .If the burner does not ignite within 5 seconds,immediately turn the control
knob back to the “OFF”position.Wait 5 minutes and repeat Step 7 up to
2 or 3 times.
9 .If the burner still does not ignite,TURN OFF THE GAS.WAIT 5 MINUTES
for excess gas to dissipate.Repeat Steps 6 and 7(if necessary).
10 . If the burner still can’t be lit,refer to the Troubleshooting section.
WARNING:
1. Make sure the hood is completely open each time you attempt to light the
grill. Failure to open the hood could lead to delayed ignition resulting in
bodily harm.
2. This grill is equipped with a flame observation hole in the side panel.Wear
protective mitts before using the flame observation hole.
CAUTION:It is important to inspect the full length of the gas line hose.If it is
evident there is excessive abrasion or wear,or the hose is cut,the
hose must be replaced prior to the appliance being used.
If required,check your parts list for the proper replacement hose assembly.
It will be necessary to open the bottom door to fully inspect the hose.
CAUTION: Regulator and hose must run outside the cart and then route through
the hole on the left side panel of the cart before connecting with tank.
See page for detailed assembly instructions.18
1 .确保控制旋钮处于“OFF”位置。
2 .打开烤架罩。
3 .检查点火销位置和销与燃烧器之间的距离。请参阅组装说明的第18步。
4 .确保安装了滴灌盘。
5 .打开液化石油气储罐。
6 .分别点燃每个燃烧器。一起打开两个燃烧器阀门可以断开流量连接(仅限LP格栅)。
7 .按下控制旋钮，将旋钮向左旋转至“最大”位置。一直按这个旋钮直到燃烧器点燃为止。
如果燃烧器在5秒内没有点燃，立即将控制旋钮转回“关闭”位置。等待5分钟，重复步骤7直到2到3次。
如果燃烧器仍然没有点燃，关闭煤气。等待5分钟，让多余的气体消散。重复步骤6和7(如果必要的话)。
10。如果燃烧器仍然不能点亮，请参阅故障排除部分。
烧烤点火指示
1。每次你试图点燃烤架的时候，确保引擎盖完全打开。不能打开引擎盖可能导致延迟点火，导致身体伤害。
2。这个烤架的侧面板上有一个火焰观察孔。使用火焰观察孔前请戴上防护手套。
注意:检查燃气管道软管的长度很重要。如果明显有过度磨损或磨损，或软管被割伤，必须在使用器具之前更换软管。
如果需要，检查你的零件清单，寻找合适的更换软管总成。有必要打开底部的门，全面检查软管。
警告:调节器和软管必须跑到车外，然后通过
在连接油箱之前，请先将车左侧面板上的孔打开。
详细的组装说明请参阅第18页。
Fig.31