Use And Care Manual

26
Match Lighting Instructions
IMPORTANT: The hood must be open when match lighting any burner.
1. Turn on gas supply
a. If portable, at the LP cylinder valve.
b. If permanent gas supply,at the manual gas shutoff valve.
2. Locate the flame observation holes on each side.
3. Access the match holder stick under right side table.
4. Attach either the match or paper to the clip(Fig.35),light the match and
insert it close to the ports of the burner,and push and turn the depressed
knob to the left to “HIGH” position.
5. The center burner (if needed)can be lit from center grid by inserting the
match clip into the front side of heat tent.Light this burner before igniting
both outside burners.
6. Depress burner valve for that burner and turn to “HIGH.”
7. Observe that the burner has ignited.Remove the match and extinguish.
8. Repeat steps 2-6 for the next burner.
Breaking in Your Grill
When firing your grill for the first time,it is advisable to run the main burner(s)
on “HIGH” for 20 minutes with the hood down,and then turn the main burners
off.This tempers the grill.
Fig. 35 Match/Paper Lighting Illustration
重要的:当火柴点燃任何燃烧器时,引擎盖必须打开。
火柴照明说明
1 .工作打开煤气供应
a .如果便携式,在LP气缸阀上。
b .如果永久气体供应,在手动气体关闭阀。
2。在两边定位火焰观测孔。
3 .工作在右侧的桌子下访问匹配的支架。
4。将匹配或纸连接到剪辑(图28),点亮匹配,并将其插入到燃烧器的端口,并将凹陷的旋钮转向“MAX”位置。
5。中心燃烧器(如果需要)可以通过将匹配夹插入热幕的前部来点燃。点燃这一燃烧器,然后再点燃炉子上的燃烧器。
6。压缩燃烧器阀门,转向“MAX”。
7。观察燃烧器已经点燃。除去火柴和熄灭。
8。重复步骤2-6为下一个燃烧器。
在第一次开火时,最好在“MAX”上运行20分钟的“MAX”,然后把主燃烧器关掉。这种脾气会使烤架转动。
OPERATING INSTRUCTIONS