Installation Sheet

ASSEMBLY INSTRUCTIONS

ITEM NO.: 6-2390-14-89/6-2390-14-322

6-2390-14-SN/6-2390-14-109

1. Carefully unpack and identify all parts referring to illustration for parts identification.

2. Turn the power to the installation point OFF.

3. Remove one hex nut (F) and lock washer (J) from nipple (N). Thread short nipple (N) into crossbar (B), and secure the

short nipple (N) with lock washer (J) and a hex nut (F) tightly by using a wrench (not included).

4. Attach the assembled crossbar (B) to the Outlet Box with the outlet box screws (C) (Size: #8-32N*0.5"L). The side of

crossbar (B) marked “GND” must face out.

5. Referring to the installation instruction with the product for the wiring and installation.

6. While holding the fixture pan (E), place fixture pan (E) over the nipple (N), adjust the length of the other end of nipple (N)

protruding through the center hole of fixture pan (E) and secure with lower hex nut (F). Secure fixture pan (E) by

threading coupling (G) into the nipple (N) until snug. (CAUTION: When handling the fixture, do not apply pressure to the

LED module. Hold the fixture by the fixture pan only.)

7. Slide the glass shade (I) upwards over center rod (H), while holding the glass shade (I), through plastic washer (O) and

metal washer (P) onto the center rod (H) and secure nut (Q) by using a wrench (not included). Secure finial (M) into nut

(Q).

8. Restore the power to the installation point ON.

9. Assembly is completely. Retain this sheet for future reference.

The LED module can be replaced by a qualified electrician without cutting of wire and without damage to any

decorative element to which the fixture is attached. See installation steps for more details.

CAUTION/ATTENTION: When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base only.

a. Shut off the power.

b. Remove finial (M), cap (K), nut (Q), metal washer (P) and plastic washer (O), remover glass shade (I) from center rod

(H).

c. Press the hole of the printed “L” quick connector on LED module with a pin to disconnected the black wire, and then

disconnect the white wire from the printed “N” quick connector on LED module.

d. Loosen coupling (G), then place fixture on a clean surface, remove plastic ring (S) from center hole of fixture pan (E).

e. Remove the screws (R), and remove the LED (T) from fixture body.

f. Reverse steps b-e for installing the new LED module.

Note: The LED module should be provided by a specified supplier.

Outlet Box