Instruction Manual

ITEM NO:M90088MBKNB
M90088WHNB
PLASTIC
ANCHORS (9)
WIRE CASING (8)
WIRE CASING CAP (6)
PLA STIC
ANCHORS (12)
UNIVERSAL MOUTING
PLATE(13)
SWIVEL(2)
ARM(4)
ARM(5)
STEEL SHADE(3)
INSTALLATION INSTRUCTIONS
1.Carefully remove the fixture out of the carton, and check that all parts are included referring to the above
illustration. Make sure not to misplace any parts that are needed for the installation;
2.Take the mounting plate (13) over the wall where you want to install this fixture and adjust it to the
proper position, then make the marks on the wall for the 2 key holes’ position.
3.Drill the holes at the position where marked at the above step , and install the plastic anchors (12) onto
them well;
4.Attach the mounting plate (13) over the wall using 2 set screws (11) thread into the plastic anchors (13)
and let the set screws (11) set at the long slot of the key hole well, then secure the set screw (11) tightly
5.Install the socket (1) into swivel (2) and steel shade (3).
6.Install the arm (4), into the arm (5).
7.Install the wire casing (8) onto plastic anchors (9), then secure them with setscrews (6).
8.Install the wire casing cap (6) onto wire casing (8).
9. Fixture is ready for lamping and installation.