SawStop ® Mobile Base Conversion Kit For use with the Professional Cabinet Saw Assembly Instructions Model MB-IND-500
Safety 1. Never place fingers, toes or other body parts under the mobile base. The base may suddenly lower on you and cause a severe injury. 2. Do not attempt to use or move the saw on an inclined surface. The saw is very heavy and difficult to stop on an inclined surface. Attempting to use or move the saw on an inclined surface could result in a severe injury. 3. Make sure the saw is fully lowered to the ground and stable before operating the saw.
Assembling Your Mobile Base The SawStop Industrial Mobile Base is designed to fit the SawStop Industrial Cabinet Saw; however this mobile base conversion kit allows the Industrial Mobile Base to be used with the SawStop Professional Cabinet Saw. In order to convert the mobile base for use with the SawStop Professional Cabinet Saw, first locate all of the conversion kit components shown on page 1. All of the hardware needed to convert the mobile base is located in the hardware bag.
Assembling Your Mobile Base 4. Take the rear support assembly and move it forward until the two mounting holes align with the next set of holes in the mobile base frame, as shown in Fig. 4. Mount the rear support assembly to the mobile base frame with two new M8 x 15.7 shoulder socket screws from the hardware bag. Fully tighten the two M8 x 15.7 shoulder socket screws with a 5 mm hex key.
Assembling Your Mobile Base 6. The conversion kit includes hold-down brackets to hold the saw in the mobile base and you must now attach the hold-down brackets to the mobile base. Begin by removing the two M8 shoulder screws that mount the left side of the front and rear support straps to the frame with a 5 mm hex key, as shown in Fig. 6. The shoulder screws may be difficult to remove because they were installed with a thread adhesive. The two M8 shoulder screws may be discarded.
Assembling Your Mobile Base 8. The mobile base is now ready for your Professional Cabinet Saw, but before placing the saw on the mobile base, it is important to rotate the rear hold-down bracket back as far as possible and to rotate the front hold-down bracket forward as far as possible (see Fig. 8). To safely place the saw into the mobile base, you will need at least four people to lift the saw off rotate hold-down the floor and then lower it onto the mobile base.
Mobile Base Conversion Kit Exploded View 3 6 3 4 5 6 3 5 2 1 ! W 2 3 1 3 AR N Ne v toe er p ING la un s or ce de oth fin r th er ge e m bo rs, ob dy p ile art ba s se . G , NIN ers rts AR fing y pa . ! W placer bodbase e e r ve th bil Ne s or o mo e toe er th d un 3 Ra is e 4 1. bo 2. dyNev ba 3. se Alw pa er pl rt pe 4. da Do on ays s unace no a e Lowl on t le use de finge sa co ve th r th rs w er thce th nt l su e whe e e in sa e m , to ue rf w n sawuppe to ace.
SawStop, LLC 9564 S.W. Tualatin Road Tualatin, Oregon 97062 www.sawstop.com Main Phone - (503) 570-3200 Service - (503) 582-9934 Fax - (503) 570-3303 Email: info@sawstop.com Updates of this manual may be available at www.sawstop.com. Copyright SawStop, LLC All Rights Reserved.