User Manual

R
aise
1. Never pla
ce fingers, to
es or other
body pa
rts under the
mobile base.
2. Always use
the saw and th
e mobile
base on a level
surface.
3. Do not
continue to ste
p on the foot
pedal once th
e upper limit is re
ached.
4. Lower
the saw before use.
Never u
se
the saw when i
t is raised off the
floor.
!
WARNING
L
ower
Never place fingers,
toes or other body parts
under the mobile base.
!
WARNING
Never place fingers,
toes or other
body parts
under the mob
ile base.
!
WARNING
SawStop Mobile Base Conversion Kit 4
Fig. 6
Fig. 7a
Fig. 7b
6. The conversion kit includes hold-down brackets to hold the saw in the mobile base and you must now attach
the hold-down brackets to the mobile base. Begin by removing the two M8 shoulder screws that mount the left
side of the front and rear support straps to the frame with a 5 mm hex key, as shown in Fig. 6. The shoulder
screws may be difcult to remove because they were installed with a thread adhesive. The two M8 shoulder
screws may be discarded.
7. Locate the two hold-down brackets and the two M8 x 18 shoulder socket screws. Use one of the M8 x 18
shoulder socket screws to install one of the hold-down brackets to the inside of the rear support strap (see
Fig. 7a). Note that the shoulder screw can only pass through the larger hole in the hold-down bracket and the
hold-down bracket must be oriented so that it bends inward toward the center of the mobile base (see Fig. 7a).
Use the remaining M8 x 18 shoulder socket screw to install the other hold-down bracket to the inside of the
front support strap (see Fig. 7b). Fully tighten both screws using a 5 mm hex key.
Never place fingers,
toes or other body parts
under the mobile base.
!
WARNING
Never place fingers,
toes or other body parts
under the mobile base.
!
WARNING
remove the two M8 shoulder
screws that mount the left side of
the front and rear support straps
front support
strap
rear support
strap
M8x18 shoulder
socket screw
M8x18 shoulder
socket screw
install a hold-down bracket
to the inside of the rear
saw strap as shown
install a hold-down bracket
to the inside of the front
support strap as shown
Assembling Your Mobile Base