SawStop ® 30” OUT-FEED TABLE INSTALLATION INSTRUCTIONS SawStop, LLC 9564 S.W. Tualatin Road Tualatin, Oregon 97062 www.sawstop.com Main Phone - (503) 570-3200 Service - (503) 682-6222 Fax - (503) 570-3303 Email: info@sawstop.
Installing Your Out-Feed Table Note: The SawStop® Out-Feed Table is designed for use with the T-GlideTM Fence System - Professional Series. It does not attach to the SawStop® Contractor Fence Assembly. 1. The out-feed table comes pre-assembled and ready to install. Begin the installation by removing the two lower M10 nylon hex nuts and the corresponding M10 x 45 hex head bolts from the angle brackets on the bottom of the table (see Fig. 1).
Installing Your Out-Feed Table 5. Align the three holes in the rear rail with the three holes in the out-feed table mounting bracket and thread the three mounting screws through the rear rail and into the mounting bracket (see Fig. 5). Thread the screws into the mounting bracket enough so they engage the bracket, but do not tighten them. They need to remain loose so you can align the out-feed table to the saw. parts belts and . Moving , cut or crush can pinch te with Do not opera open. belt guard Fig.
30” Out-Feed Table Assembly Exploded View 1 8 10 9 3 3 4 2 3 7 6 5 30” Out-Feed Table Assembly Parts List No. Description 30 Inch Out-Feed Table Assembly (includes items 1-10) Part No. Qty. OFT30-CNS-000 1 1 Out-Feed Table OFT30-001 1 2 Out-Feed Table Mounting Bracket OFT30-002 1 3 M4x1.59x16 Phillips Head Screw OFT30-003 17 4 M8x30 Hex Head Screw OFT30-004 6 5 Foot OFT30-005 2 6 M8x1.25 Hex Nut OFT30-006 2 7 Support Leg OFT30-007 2 8 M10x1.
