User guide

Item Description Part number Qty
A L-Bracket TSA-ODC-001 2
B M8x1.25x20 Hex Head Bolts TSA-ODC-002 2
C Lower Dust Tube TSA-ODC-003 1
D1 Dust Tube Clamp TSA-ODC-004 2
D2 M6x1x30 Button Head Screw TSA-ODC-005 2
D3 M6x1x10 Set Screw TSA-ODC-006 2
E Dust Port Splitter TSA-ODC-007 1
F Upper Dust Tube TSA-ODC-008 1
G Short Dust Hose (without hose connectors) TSA-ODC-009 1
H Long Dust Hose (without hose connectors) TSA-ODC-010 1
I 1.5” Hose Connector TSA-ODC-011 4
- SawStop Label (installed on upper metal tube) TSA-ODC-012 1
hose connector
(placed on each end of hose)
D2
D3
D1
I
2.
Position clamps D on rear rail or brackets
and tighten set screws.
3 mm
hex key
C
D
D
rear rail
4 mm hex key
3.
Tighten the screws that clamp tube C.
4.
Slide splitter E onto the dust port at rear of saw oriented as shown below.
E
E
(for a cabinet saw) (for a contractor saw)
5.
Insert tube F into tube C.
F
C
Connect hoses.
6.
G
H
Contractor saw: make sure hose clears motor as the
blade moves through its full range of elevation and tilt.