Instruction Manual

Installing Your T-Glide Fence System
Contractor Saw
5. Finish mounting the rear rail to your saw by inserting an M8 x 25 countersunk socket head bolt through the
open hole at the end of each extension wing (see Fig. 5a), and placing an M8 washer, an M8 lock washer,
and an M8 hex nut on the threaded end of each bolt (see Fig. 5b). Hand tighten the nuts; do not fully
tighten them.
level the extension wing
and tighten the nut on the
bolt that goes through the
extension wing
Fig. 6
6. Use a straight-edge to level the front edge of the left
extension wing to the cast iron table top (see Fig. 6).
You may have to pull up or push down on the outer
edge of the extension wing to level it. Once the front
edge of the left extension wing is level, use a 5 mm
hex key and a 13 mm wrench to fully tighten the nut
on the bolt that mounts the left extension wing to the
front rail. Repeat this process to level the front edge
of the right extension wing and the rear edges of the
left and right extension wings.
straight-edge
Ma
d
e
i
n
T
a
i
wan
SawSt
op
,
L
L
C
ww
w
.s
a
w
s
t
o
p
.
c
om
T
CP
10¨ Contracto
r Saw
SawStop
®
Model No. CNS 175
Serial No. C0740
12345
Electrical / Electricid
ad /
Électricité
1
15/230
V
olts
, 60 Hz
15/7.5
Am
p
s
1 Phase
1.75 HP
3500 RPM
®
c
US
1
7537
0
M
o
ving
b
elts and pa
r
ts
c
an pinch
,
cut or c
r
ush.
D
o not o
p
e
r
a
t
e with
b
elt gua
r
d o
p
en.
Fig. 5a
2
rear rail
2
3
4
5
Fig. 5b
SawStop T-Glide Fence System - Professional Series II 11