Instruction Manual

Installing Your T-Glide Fence System
SawSt
op, the SawStop blade l
ogo, and the
configu
ration of this product are either
registered
trademar
ks or trademarks of S
a
wSt
op, LLC.
Softw
are copyright 2003-2006
by
SawStop, LLC.
All righ
ts
r
eserved. Protected by
one or more of
the
following U.S. patents
68
139
8
3,
6826988,
6857345,
6877410, 6880440, 692
0814, 6945148,
6945149,
6957601, 6994004, 6997090
, 7000514,
7024975,
7055417, 7077039, 709
8800, 7100483,
7137326,
7171879, 7197969, 7210383
, 7225712,
7228772,
7231856 and Taiwan p
a
te
nt 143466.
Addition
al U.S. and foreign paten
ts pending.
!
WARNING
Do no
t remove the
dust s
hroud be
cause
the blade w
ill be expose
d. If yo
u contact
the
blade un
der the tab
le, the blade
may ret
ract
toward
you and c
ause a sever
e injury.
15. Repeat the process described in the previous step to level the rear edge of the extension table to the cast iron
table top (see Fig. 15).
16. Turn the foot on the bottom of each support leg to adjust its position until it is in solid contact with the ground.
Once the foot is in contact with the ground, fully tighten the hex nut against the bottom of the leg using a
13 mm wrench (see Fig. 16).
Fig.
15
Fig.
16
adjust the position of
the foot and tighten
the hex nut
straight-edge
8 SawStop T-Glide Fence System - Professional Series