Instruction Manual

Installing Your T-Glide Fence System
Made in Taiwan
SawStop
, LLC
www.sawstop.com
TCP
10¨ Contractor Saw
SawStop
®
Model No. CNS 175
Serial No. C074
012345
Electrical / Elect
ricidad / Électricité
115/230 Volts, 60 Hz
15/7.5 Amps
1 Phase
1.75 HP
3500 RPM
®
c
US
175370
Moving belts and parts
can pinch, cut or crush.
Do not operate with
belt guard open.
11
12
13
14
11
1
5
Made in Taiwan
SawStop, LLC
www.sawstop.com
TCP
10¨ Contractor Saw
SawStop
®
Model No. CNS 175
Serial No. C0740
12345
Electrical / Electricidad /
Électricité
115/230 Volts
, 60 Hz
15/7.5 Amps
1 Phase
1.75 HP
3500 RPM
®
c
US
175370
Moving belts and parts
can pinch, cut or crush.
Do not operate with
belt guard open.
6. Align the rear rail (the smaller of the two rails) with the rear edge of the table top so the cut-outs at the top of
the rail are centered on the miter gauge slots in the table and so the holes in the rail align with the holes along
the back edge of the table and extension wings. Notice that the holes in the table are threaded but the holes
in the extension wings are not. Remove four M8 x 16 countersunk socket head screws from the T-Glide rails
hardware pack and thread one
through each of the holes in
the rail and into the threaded
holes in the table (see Fig. 6).
Tighten the four screws using
a 5 mm hex key.
Fig.
6
7. Take two M8 x 25 countersunk socket head bolts and insert one through each hole in each extension wing.
Place an M8.5 x 23 washer and an M8 lock washer on the back of each bolt and then thread an M8 hex nut on
each bolt (see Fig. 7). Hand tighten the nuts; do not fully tighten them.
Fig. 7
rear rail
4 SawStop T-Glide Fence System - Professional Series