Use and Care Manual

Setting up the Saw Trax Panel Kit
Slide the two guide tube rails through
the carriage bearings. Lock one side of
the carriage to one guide rail using the
carriage lock. Position the guide rail
support brackets at either end so the side
with the “closed” towers is facing the
carriage. Attach the guide rails to the rail
support bracket towers so the guide
rail does not go beyond the top
clamping flap edge. Use a socket /
ratchet to tighten the nuts on the towers.
Lock the carriage in the center of both
guide rails.
Guide Tube Rails
Rails Support Brackets
Carriage
Carriage Lock
Clamping
Flap Edge
Carriage
Bearings
Towers