Use and Care Manual

14 | P a g e
lip
Base
plate
UAccessories – Installation & Use
TTMid-FenceTT - Instead of cutting small pieces on the bottom rollers of the
machine, use the mid fence to hold small pieces. This allows for
easy waist high cuts.
a. This accessory is Pre-installed
b. The base plate is a fixed plate and the lips are removable.
Remove the lip when cutting larger sheets. To remove the lips,
simply lift the lip up and pull outward.
c. To attach the lip, line the tabs with the slots of the base plate.
Insert the tabs and make sure they completely drop into the slot.
TTBuilders ExtensionsTT - Changes a Compact into a full size base or a Full Size
base to one that is almost 15' wide. It is ideal for making
it easier to rip a full size sheet on a Compact on a regular
basis.
a. FULL SIZE UNITS ONLY: You will need to remove the
existing side stand legs before installing the extensions.
b. Align the square holes on the edge of each extension with the
square holes on the unit. Insert the provided bolts through each
of the two holes. Attach the washer and the nut to the back side
of each bolt.
c. Align the fence along the top edge and tighten the nuts.
d. On the outside end of the extension, attach the side stand legs in
an “A” shape. (as shown in the picture) They must come in
contact with the floor to stabilize the unit.
e. Attach measuring tapes. (see installation instructions)
TTSpring hold downTT – Holds thin material against the fence while cutting.
Recommended for material 1/4" or thinner.
a. This accessory is Pre-installed
b. The design of the spring fingers will allow material up to ¼P
”
P
thick to be inserted from either side.
c. Adjust the tension by loosening the black knob located at the
top of the spring hold down. (located at the bottom for taller
units) Then rotate the spring hold down & retighten the black
knob.
d. The spring hold down can be removed as needed.
b.
c.
d.
d.
b.
b.
b.
c.
c.