Use and Care Manual

7 | P a g e

c. Make sure the dust cover of the saw is positioned above the motor.

(As in the Picture)

d. Place the saw so the saw blade is touching your piece of material.

(Make sure the blade guard is out of the way)

e. Secure the place of the saw by locking down the carriage locks.

f. Peel the backing of the measuring tape and match tape (example: 21

inches) with top rip pointer on the carriage. (Classic model only has 1

pointer) Then adhere the tape to the entire banding.

g. Remove & re-insert the plate with the motor above the dust hood.

(Repeat step d & e).

h. Adjust the bottom pointer by loosening the bolts and moving the

pointer to read the same measurement. (example: 21 inches) Then re-

tighten the bolts.

10. TT Attaching the dust brush

a. Place the brush around the saw blade on the bottom of the saw plate.

Brush is magnetic so it can be removed for cutting thick material.

b. You may permanently attach it by using a self tapping screw to secure

it to the plate. Be careful not to drill into the saw.

11. TT Placement of the dust collection hose & power cord

a. Place power cord in the V shape of the cord holder and place plug end

behind the units frame.

b. Feed the vacuum hose through the hose channel and make sure

smaller end is in the front of the unit.

c. Connect smaller end to dust port on the saw hood.

d. Connect the larger end to a vacuum (not provided). A coupler is

provided so you may connect 2 vacuum hoses together.