Owner`s manual

Page 10 of 20
Rear
derailleur
5
Rear
derailleur
Rear
Brake
Front
derailleur
6
 Fig.5: Install each pre-cut housing over each derailleur cable, and into the entry port holes. Be sure to match the housing lengths to the correct
cables. For hydraulic brakes, do not place any housing over the cable, as v this cable will be used to guide the hydraulic housing from the bottom.
 Fig.6: Push the derailleur cable housing(s) through the entry port hole(s) until they become visible at the exit port hole.
8
7 8
Run brake housing on inside
of seatstay and chainstay
 Fig.7: Place the correct exit port hood scoop over the derailleur housing(s). Keep the cable intended for the rear brake out of the hood scoop.
 Fig.8: Hydraulic brakes: With the hydraulic housing disconnected from the brake lever, install the rear brake caliper on the seatstay brake mount,
then run the housing through the exit port hood scoop brake hole. Tape the housing to the brake cable. Fasten the hood scoop to the frame.
9
FOAM:
52cm
10
S149900018
FOAM ICR SLEEVE 11MM OD
 Fig.9: Pull the cable attached to the brake housing until the housing comes out the entry port hole.
 Fig.10: Install a section of 52cm long foam tubing (talc pre-applied at factoryv) over each section of housing, through the entry port hole.