Owner`s manual

Page 5 of 20
TCCT (Top Cap Chain Tool)
TCCT INTO ALLOY STEERER TUBE:
53214-1160
A
: TCCT
B
: Star Nut Tool Extender
A
B
28.6mm
1 1/8”
1
PARK
TNS-4
33mm
2 3 4
DO NOT EXCEED:
GAP:
> 1.5mm
< 4.5mm
 Install the star nut, then thread the TCCT into the star nut. Tighten the bolt down to adjust headset tension just like a regular top cap.
NOTE: In order to ensure a straight installation of the star nut, Specialized recommends the use of the Park Tool TNS-4 Threadless Star Nut Setter.
NOTE: Installation of the TCCT with a Specialized ProSet multi-position stem (angle-adjustable): To prevent excessive side-loading of the bolt,
the use of a 2 or 4 degree angled headset spacer (S142500006) is required.
 Do not exceed 25 in-lbf (2.8 Nm) of torque on the top cap bolt.
TCCT INTO CARBON STEERER TUBE: USING THE TCCT:
53214-1165
28.6mm
1 1/8”
1 2
DO NOT EXCEED:
GAP:
> 1.5mm
< 4.5mm
1
2
3
4
 Install the expander plug with the slit facing toward the front of the bike (180 degrees from the bolts). Tighten the bolt down to adjust headset
tension just like a regular top cap.
NOTE: The TCCT can be installed on additional bike models. Carbon steerer tubes require the TCCT-specific expander plug. Part # 53214-1165 only
fits carbon steerer tubes with an internal diameter between 23 and 24mm, and a consistent depth of 55mm.
NOTE: The TCCT requires the use of a quick-connect link to re-attach the chain.