Installation guide

6 Installation Instructions Efficient Networks, Inc.
Installation Instructions
NOTE: The labels for the back panel of the 5260 are located on the
underside of the unit.
1 Be sure the Power button is in the OFF position.
2 Plug the power cable into the power connection on the back of the
unit; then connect it to a power outlet.
3 Connect the Ethernet port (ENET) on the 5260 to the Ethernet port on
your computer using the gray-colored RJ45 cable provided. To
connect the Ethernet port to a hub, you must use a crossover cable
(not included).
4 Use the RJ11 cable to connect the 5260’s DSL port to the DSL
service port (wall jack) installed by your DSL service provider.
5 Press the Power button to turn on the unit.
6 Check the front panel LEDs (described in the next section) for proper
functioning.
Power
(Out=OFF, In=ON)
DSL
Connection
Ethernet
Connection
Power
Connection