Quick Installation Guide

ManualsBrandsSBO Hearing ManualsElectronicsHearing Aid Module

Table Of Contents

Oticon Radio Model - Regulatory Label Information for USA & Canada
- This device complies with Part 15 of the FCC Rules and with RSS-210 and RSS-247 of Industry Canada.
  - Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:

SBO Radio Model - Quick Installation Guide

Radio Model Name: SBO BTE UP

SBO Hearing A/S

Main +45 39 17 71 00

Kongebakken 9

Fax +45 39 27 79 00

DK-2765 Smørum

Denmark

www.sbohearing.com

On the bottom side of the main PCB of the SBO BTE UP radio model the connector for the speaker unit assembly (where the wire antenna for the Bluetooth

radio is an integrated part), the programming connector, EEPROM memory and coil antenna for the 3.84 MHz radio can be seen:

The most important parts inside the Engine module are a Digital-Signal-Processor (DSP), a radio Front-End (FE) chip for the 3.84 MHz radio part and an RF chip

for the Bluetooth radio part – all mounted on a small rigid PCB again mounted on the main flex PCB. The SBO BTE UP radio model also includes all voltage

regulators and buffered data programming inputs on board. The DSP is the main processor controlling the functionality of both radios in the SBO BTE UP radio

model.

The SBO BTE UP radio model is intended to be installed in Oticon, Bernafon, Sonic, SBO Hearing and affiliated wireless hearing aid devices of the SBO BTE UP

(Behind The Ear, Super Power) wearing style.

SBO BTE UP Radio Model – Main PCB – Bottom side