User's Manual

28 29
Pairing
Top LED
indicator
Description
FittingLINK in pairing mode
Pairing complete
Flash Steady
When the pairing is finished, open your fitting software, detect and select FittingLINK
as your programming device. It is necessary to perform and complete this selection
procedure only once.
FittingLINK is now ready for programming the hearing instruments.
Connect to a PC via the USB cable
To connect FittingLINK to your PC with the USB cable, insert the USB cable in the
USB port in the bottom of FittingLINK and then insert the other end of the cable in a
USB port on your PC.
Turn ON your PC and then turn ON FittingLINK. Open your fitting software, detect and
select FittingLINK as your programming device. It is only necessary to perform and
complete this selection procedure the first time.
FittingLINK is now ready for programming wireless hearing instruments.
Please note, you can leave the Bluetooth adaptor in your
PC while connecting via the USB cable.
IMPORTANT NOTICE
If you connect the USB cable to a non-powered USB hub, FittingLINK may not charge.
It is recommended to connect the USB cable directly to your PC.