User's Manual

50 51
Technical information Bluetooth adaptor
This device contains a module with:
FCC ID: DMOCBBSKE
IC: 2099D-BTD800
The device complies with Part 15 of the FCC rules and RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
• Consult your supplier for help.
Changes or modifications made to this equipment not expressly approved by the party
responsible for compliance may void FCC authorization to operate this equipment. This
Class B digital apparatus complies with Canadian ICES-003.
RF Radiation Exposure Information
Since the radiated output power of this device is far below the FCC radio frequency limits,
it is not subjected to routine RF exposure evaluation as per Section 2.1093 of the FCC
rules. This device complies with the US and Industry Canada portable device RF exposure
limits set forth for an uncontrolled environment and is safe for intended operation as
described in the user manual.