Operating instructions

INSTALLING THE AT10.1

1.5.2. Floor-Mounting the AT10.1

To floor mount the AT10.1, you must use the floor mounting accessory kit

(EI0192-00). For kit availability, see ordering information in Appendix

B on page 71. The kit contains brackets that elevate the top of the AT10.1

approximately 47in / 1194mm above floor level, with provision for floor

anchoring. The kit includes an instruction sheet (JA0083-00

) showing

assembly dimensions and mounting details.

You must locate the anchor-bolt holes at least 4.25in / 108mm from any

wall, to allow clearance for the charger enclosure behind the mounting

brackets. In addition, you must consider the following:

1. Placement of conduit entrances (use the knockouts on the sides or bottom of

the charger to allow access for servicing without removing the unit from the

mounting brackets).

2. The location:

• Should be free of drips and splatter. If dripping liquids are a problem,

install a drip shield kit (EI0191-00). For kit availability, see ordering

information in Appendix B on page 71.

• Should be between 32 and 122 °F / 0 and 50 °C, with relative humidity

between 5 and 95% non-condensing.

• Must be free of explosive materials.

3. Maintain at least 6in / 152mm of free air on top, bottom and both sides for

cooling air.

4. Allow 36in / 914mm front clearance for operation and maintenance.

PROCEDURE

To floor-mount the AT10.1,

follow the directions featured in

instruction sheet (JA0083-00

included with your floor-

mounting kit (EI0192-00).

These instructions showing

assembly dimensions and

mounting details.

Place the AT10.1 assembly on

the mounting bolts, add

appropriate mounting hardware

and tighten.

Reference the graphics on the

next page.