Operator`s manual

Section 3

Install the front hinge bracket to the cutter deck using 16.

two (2) 5/16-18 x 3/4" bolts and two (2) 5/16-18

elastic stop nuts. See Figure 3-3, page 6. Do not

tighten the hardware.

Install the block off plate weldment to the front and 17.

rear hinge brackets using two (2) 5/16-18 x 3-1/2"

bolts and two (2) 5/16-18 elastic stop nuts. See

Figure 3-5. Do not tighten the bolts completely.

Secure the hardware so the block off plate weldment

moves freely.

Block O

Plate Weldment

Block Off Plate Weldment InstallationFigure 3-5.

Tighten the mounting hardware securing the front 18.

and rear hinge brackets.

Install the OCDC pivot bracket to the cutter deck. 19.

Secure using one (1) 5/16-18 x 1" bolt, one (1) 5/16"

flatwashers, one (1) 5/16" lockwashers and one (1)

5/16-18 elastic stop nuts. Do not tighten hardware at

this time. See Figure 3-6.

Using the OCDC pivot bracket as a guide, locate 20.

and drill the required hole in the discharge chute

mounting rail using an 11/32" drill bit. See Figure

3-6.

Secure the OCDC pivot bracket to the discharge 21.

chute mounting rail using one (1) 5/16-18 x 1" bolt,

one (1) 5/16" flatwasher, one (1) 5/16" lockwasher

and one (1) 5/16-18 elastic stop nut. See Figure 3-6.

Tighten the hardware installed in step 19 and 21.22.

OCDC Pivot Bracket

Discharge Chute

Mounting Rail

Center Punch &

Drill 11/32” Hole

HHCS

5/16-18

1-1/2”

5/16-18

Stop Nut

SCZ/STC 48V OCDC Pivot Bracket InstallFigure 3-6.