Operator`s manual

16
R
Section 3
Install the front hinge bracket to the cutter deck using 16.
two (2) 5/16-18 x 3/4" bolts and two (2) 5/16-18
elastic stop nuts. See Figure 3-21, page 14. Do not
tighten the hardware.
Install the block off plate weldment to the front and 17.
rear hinge brackets using two (2) 5/16-18 x 3-1/2"
bolts and two (2) 5/16-18 elastic stop nuts. See
Figure 3-23. Do not tighten the bolts completely.
Secure the hardware so the block off plate weldment
moves freely.
Block O
Plate Weldment
Block Off Plate Weldment InstallationFigure 3-23.
Tighten the mounting hardware securing the front 18.
and rear hinge brackets.
Install the OCDC pivot bracket to the cutter deck. 19.
Secure using two (2) 5/16-18 x 1" bolt, two (2) 5/16"
flatwashers, two (2) 5/16" lockwashers and two (2)
5/16-18 elastic stop nuts. See Figure 3-24.
OCDC Pivot Bracket
STT52V Cutter Deck
OCDC Pivot Bracket
STT61V Cutter Deck
OCDC Pivot Bracket InstallFigure 3-24.