Specifications

Trend Micro™ OfficeScan™ 10 Administrator’s Guide
9-8
Scheduled Scan Privileges
Clients set to run Scheduled Scan can have the privileges to postpone and skip/stop
Scheduled Scan. To allow users to take advantage of these privileges, remind them about
the privileges you have granted them by configuring OfficeScan to display a notification
message before Scheduled Scan runs.
To display the notification message, go to Networked Computers > Client
Management > Settings > Privileges and Other Settings > Other Settings tab >
Scheduled Scan Settings and enable Display a notification before Scheduled Scan
occurs.
The notification message display minutes before Scheduled Scan runs. To configure the
number of minutes, go to Networked Computers > Global Client Settings >
Scheduled Scan Settings > Remind users of the Scheduled Scan __ minutes
before it runs.
Postpone Scheduled Scan
Users with the "Postpone Scheduled Scan" privilege can perform the following actions:
• Postpone Scheduled Scan before it runs and then specify the postpone duration.
Scheduled Scan can only be postponed once.
• If Scheduled Scan is in progress, users can stop scanning and restart it later. Users
then specify the amount of time that should elapse before scanning restarts. When
scanning restarts, all previously scanned files are scanned again. Scheduled Scan can
be stopped and then restarted only once.
Note: The minimum postpone duration/elapsed time users can specify is 15 minutes.
The maximum is 12 hours and 45 minutes, which you can reduce by going to
Networked Computers > Global Client Settings > Scheduled Scan Settings
> Postpone Scheduled Scan for up to __ hours and __ minutes.