Technical data

ACCESSORIES
20
12 distance bushings for soap stone
12 screws 6 x 30 mm for soap stone
The high top and the chimney are mounted as described in the sec-
tion ”Mounting of high top for Scan 58-7 and Scan 58-8 on page 21”.
I
I
Scan 58-9 and Scan 58-10 with high top
4 gaskets each 35 cm
In order to prepare the stove for mounting of soap stones, we refer
to the section ”Scan 58-9 and Scan 58-10”, page 19. However, the soap
stones must be mounted according to the size as shown below (the
smaller stone in the middle).
The delivered gasket should be cut in pieces of 35 cm and sticked onto
the high top of the stove, on the outer side of the markings as shown
below.
Each soap stone must be mounted with distance bushings and
screws (pos. I). These are delivered with the soap stone and the high
top.