User manual

// 7
ENGLISH / Connecting your loudspeakers
We recommend that you read the manual of your amplifier or av-receiver carefully before connecting
your MicroPod SE loudspeakers. Please switch off all equipment when connecting MicroPod SE.
The binding posts on the terminal accepts wire up to Ø 4mm or cables with bananaplugs.
Make sure that the positive terminal binding posts on MicroPod SE (coloured red) are connected to the
positive output terminal binding posts on the amplifier and that the negative terminals on MicroPod SE
(coloured black) are connected to the negative output terminal on the amplifier.
Note! The connecting cable consists of a round and a square cable.
Make sure that the square cable is connected to the black binding post and the round
cable is connected to the red binding post on both speakers.
You are now ready to enjoy the great sound of MicroPod SE.
ENGLISH / Running-in period
We recommend a running-in period of your new MicroPod SE loudspeaker of approximately 15-20 hours at normal listening level
before you decide on the final positioning of the loudspeaker.
During the running-in period, the drive units will settle in and perform as intended.
ENGLISH / Care and cleaning
We strongly advise against the use of any solvents or cleaners on the lacquered MicroPod SE cabinet. The cabinet surface usually
only requires dusting or cleaning with a damp soft cloth (only use cold clean water). Avoid touching the drive units, especially the
tweeter, as damage may result.
ENGLISH / Environmental information
MicroPod SE complies with international directives on the Restriction of Hazardous Substances (RoHS) in electrical and electronic
equipment and the disposal of Waste Electrical and Electronic Equipment (WEEE) - the crossed bin symbol indicates compliance and
that the products must be appropriately recycled or processed in accordance with these directives.
ENGLISH