User Manual

X-GAUGE saved in that memory slot. Saving the new X-GAUGE in that particular slot will overwrite
any X-GAUGE data already present in that memory slot. Once you have the desired memory slot
selected, press lower right function button next to SAVE. All the data will be written to that X-GAUGE
memory slot, leaving the previously selected memory slot unchanged.
Disabling an X-GAUGE
To disable an X-GAUGE already in memory, start as if you were going to edit the gauge. In the TXD
Screen, change the first character to a space. Continue to step through the editing fields by pressing the
lower right function button next to OK and press SAVE to exit the screen. This will actually delete the
data to transmit, which tells the ScanGauge not to use this X-GAUGE. The name will not be displayed.
If you put transmit data back into this gauge, it will be reactivated.
Displaying a Trip Value as an X-GAUGE
You can set any of the built-in trip values and
have them displayed as a gauge. This allows you
to monitor trip functions along with other gauge
functions.
In the example to the right, a custom X-GAUGE that
displays the Time Driven Today is set up.
Step 1
To get started, choose an empty memory slot from
the X-GAUGE Screen. Then press the lower left
function buttons next to EDIT.
Step 2
In the TXD Screen, the first character determines
which trip function will be displayed. Choose a
number from the Available Trip Parameters chart
on the next page.
The second character determines which trip to use.
Choose a number from the Trip Designations chart
on the next page.
When you’re done, press the lower right function
button next to OK to move to the next screen.
Step 3
For RXF, make the first character an 8 as shown to
the right.
An 8 as the first character is a special condition that
tells the ScanGauge that this is to be a trip gauge. All
values after the 8 are ignored.
When you’re done, press the lower right function
button next to OK to move to the next screen.
Step 1
Step 2
Step 3
Step 4 - 5
Step 6
Step 7
<EDIT
<XGAUGE
EXIT>
2>
-
+51_
OK>TXD
»
-
[phone]
_
OK>RXF
»
-
+0000
OK>RXD
»
_
-
+TDT
OK>NAME
»
<CANCEL
<XGAUGE
SAVE>
TDT 2>
Make no changes to the RXD and
MTH program parameters
42 — www.ScanGauge.com