Specifications

 Show speed signs: If you set this option then a valid speed limit is shown for

the section of road you are currently driving on.

Traffic safety

The system only shows the general speed. Always take into account

the speed limits that apply for your vehicle.

Note

Speed limits can only be shown if they are included in the navigation

data.

Always observe existing traffic signs and always adjust your speed to

the actual speed limit.

 Show points of interest (POIs) on the map: If you set this option then points

of interest (POIs), e.g. petrol stations, car parks or restaurants, are marked by

corresponding symbols on the map.

 Map Data Information: Use this option to show the name and version of the

map data stored on the SD card.

 Voice Guidance: If you set this option then voice messages will be played back

during navigation.

 Volume: If voice guidance is activated then this setting changes the volume of the

voice commands. You will hear a sound sample after each change.

 Position Information: Use this option to show the address/GPS coordinates for

the current position. To save the address/GPS coordinates shown in the address

book, tap on "Save".

 Time Display: Use this option to change between showing the estimated time of

arrival and the estimated travel time remaining. See the chapter "Information on

the map" for more information.

 Distance Units: This option allows you to change between showing the distance

in miles and in kilometres.

 POI Warning: This option is available if user-defined POIs with corresponding

warning messages have been downloaded into the system. If this option is

activated then a warning message is shown when the vehicle approaches a user-

defined POI.

Note

See the chapter ”User-defined points of interest (POI)” for more

information.

 POI Warning Distance: This option is only available if the user-defined POIs and

corresponding warning messages have been downloaded into the system. Using

this menu option you can define the distance at which you want to receive a

warning before reaching a user-defined POI. Proceed as follows in order to set

the distance: