User Manual
Table Of Contents
- CAN interface for bodywork
- Introduction
- Summary of CAN messages
- Detailed description of CAN messages
- Explanation
- CAN messages sent to the vehicle
- CAN messages sent from the vehicle
- Software identification
- Scania bodywork status message 1
- Air Supply Pressure
- Air Suspension Control 1
- Alarm Status Proprietary
- Ambient Conditions
- BAM-E
- Cab Illumination Message
- Cab Information Proprietary 1
- Cruise Control/Vehicle Speed
- Crash Occured
- Coordinator General Information
- Coordinator General Information 2
- CUV information
- Dash Display
- DLN2-Proprietary
- DLN5-Proprietary
- DLN8-Proprietary
- DM1
- EAC1-K
- EBC1
- EBC2 Wheel Speed Proprietary
- EBC4 Wheel Brake Lining Remaining Information
- EBC5
- EEC1
- EEC2
- Engine Configuration Messages
- Engine Fluid Level/Pressure 1
- Engine Hours, Revolutions
- Engine Temperature
- ERC1-RD
- ETC1 - T
- ETC1 - CV
- ETC2
- ETC7
- Fuel Consumption
- Fuel Economy
- High Resolution Vehicle Distance
- Inlet/Exhaust Conditions
- PTO information Proprietary
- Retarder Fluids
- Supply Pressure
- TCO1
- Time/Date
- Transmisson Control 1 (TC1)
- Transmission Fluids
- Transmission Proprietary/DLN5
- Transmission Proprietary 2 - T
- Transmission Proprietary 2 - AWD
- Vehicle Weight
- Vehicle Weight
- Requirements for CAN communication with the vehicle
©
Scania CV AB 2013, Sweden
CAN interface for bodywork
Detailed description of CAN messages
11:90-01 Issue 1 en-GB 122 (139)
Transmission Proprietary/DLN5
Identifier: 18 FF A0 27
Transmission interval: 50 ms
Always sent from BWS.
A: Only contains information if a manual gearbox is installed.
Byte Bit Length Explanation State Resolution Limits Note
112Split switch A
Low 00
High 01
Error 10
Not available 11
32Range switch A
Low 00
High 01
Error 10
Not available 11
5..8 Not defined
2 1..8 Not defined
318Clutch pedal position 0.4%/bit 0 to 100 %
Error FEh
Not available FFh
4..8 Not defined