User Manual
Table Of Contents
- CAN interface for bodywork
- Introduction
- Summary of CAN messages
- Detailed description of CAN messages
- Explanation
- CAN messages sent to the vehicle
- CAN messages sent from the vehicle
- Software identification
- Scania bodywork status message 1
- Air Supply Pressure
- Air Suspension Control 1
- Alarm Status Proprietary
- Ambient Conditions
- BAM-E
- Cab Illumination Message
- Cab Information Proprietary 1
- Cruise Control/Vehicle Speed
- Crash Occured
- Coordinator General Information
- Coordinator General Information 2
- CUV information
- Dash Display
- DLN2-Proprietary
- DLN5-Proprietary
- DLN8-Proprietary
- DM1
- EAC1-K
- EBC1
- EBC2 Wheel Speed Proprietary
- EBC4 Wheel Brake Lining Remaining Information
- EBC5
- EEC1
- EEC2
- Engine Configuration Messages
- Engine Fluid Level/Pressure 1
- Engine Hours, Revolutions
- Engine Temperature
- ERC1-RD
- ETC1 - T
- ETC1 - CV
- ETC2
- ETC7
- Fuel Consumption
- Fuel Economy
- High Resolution Vehicle Distance
- Inlet/Exhaust Conditions
- PTO information Proprietary
- Retarder Fluids
- Supply Pressure
- TCO1
- Time/Date
- Transmisson Control 1 (TC1)
- Transmission Fluids
- Transmission Proprietary/DLN5
- Transmission Proprietary 2 - T
- Transmission Proprietary 2 - AWD
- Vehicle Weight
- Vehicle Weight
- Requirements for CAN communication with the vehicle
©
Scania CV AB 2013, Sweden
CAN interface for bodywork
Detailed description of CAN messages
11:90-01 Issue 1 en-GB 15 (139)
Scania Bodywork Control Message 2
Identifier: 0C FF F9 XX
Transmission interval: 100 ms
Byte Bit Length Explanation State Resolution Limits Note
118Message configuration version 02h 0 to 250 A
212Increased idle speed switch 1 (ISSW1) B
ISSW1 not demanded 00
ISSW1 demanded 01
Error indicator 10
Not available or not installed 11
32Increased idle speed switch 2 (ISSW2) C
ISSW2 not demanded 00
ISSW2 demanded 01
Error indicator 10
Not available or not installed 11
5..8 Not defined
312Second vehicle speed limiter
Speed limit not requested 00
Speed limit requested 01
Error indicator 10
Not available or not installed 11
3..4 Not defined
52Torque limit 1
Torque limit 1 not requested 00
Torque limit 1 requested 01
Error indicator 10