User Manual
Table Of Contents
- CAN interface for bodywork
- Introduction
- Summary of CAN messages
- Detailed description of CAN messages
- Explanation
- CAN messages sent to the vehicle
- CAN messages sent from the vehicle
- Software identification
- Scania bodywork status message 1
- Air Supply Pressure
- Air Suspension Control 1
- Alarm Status Proprietary
- Ambient Conditions
- BAM-E
- Cab Illumination Message
- Cab Information Proprietary 1
- Cruise Control/Vehicle Speed
- Crash Occured
- Coordinator General Information
- Coordinator General Information 2
- CUV information
- Dash Display
- DLN2-Proprietary
- DLN5-Proprietary
- DLN8-Proprietary
- DM1
- EAC1-K
- EBC1
- EBC2 Wheel Speed Proprietary
- EBC4 Wheel Brake Lining Remaining Information
- EBC5
- EEC1
- EEC2
- Engine Configuration Messages
- Engine Fluid Level/Pressure 1
- Engine Hours, Revolutions
- Engine Temperature
- ERC1-RD
- ETC1 - T
- ETC1 - CV
- ETC2
- ETC7
- Fuel Consumption
- Fuel Economy
- High Resolution Vehicle Distance
- Inlet/Exhaust Conditions
- PTO information Proprietary
- Retarder Fluids
- Supply Pressure
- TCO1
- Time/Date
- Transmisson Control 1 (TC1)
- Transmission Fluids
- Transmission Proprietary/DLN5
- Transmission Proprietary 2 - T
- Transmission Proprietary 2 - AWD
- Vehicle Weight
- Vehicle Weight
- Requirements for CAN communication with the vehicle
©
Scania CV AB 2013, Sweden
CAN interface for bodywork
Detailed description of CAN messages
11:90-01 Issue 1 en-GB 41 (139)
Cruise control activator not in the position "coast" 00
Cruise control activator in the position "coast" 01
Error indicator 10
Not available or not installed 11
52Cruise control resume switch
Cruise control activator not in the position "re-
sume"
00
Cruise control activator in the position "resume" 01
Error indicator 10
Not available or not installed 11
72Cruise control accelerate switch
Cruise control activator not in the position "accel-
erate"
00
Cruise control activator in the position "acceler-
ate"
01
Error indicator 10
Not available or not installed 11
618Cruise control set speed 1 km/h 0 to 250 km/h
Error indicator FEh
Not available or not installed FFh
715PTO state 0 to 31
Off/disabled 0000
Hold 0001
Remote hold 0010
Standby 0011
Remote standby 0100
Byte Bit Length Explanation State Resolution Limits Note