User Manual
Table Of Contents
- CAN interface for bodywork
- Introduction
- Summary of CAN messages
- Detailed description of CAN messages
- Explanation
- CAN messages sent to the vehicle
- CAN messages sent from the vehicle
- Software identification
- Scania bodywork status message 1
- Air Supply Pressure
- Air Suspension Control 1
- Alarm Status Proprietary
- Ambient Conditions
- BAM-E
- Cab Illumination Message
- Cab Information Proprietary 1
- Cruise Control/Vehicle Speed
- Crash Occured
- Coordinator General Information
- Coordinator General Information 2
- CUV information
- Dash Display
- DLN2-Proprietary
- DLN5-Proprietary
- DLN8-Proprietary
- DM1
- EAC1-K
- EBC1
- EBC2 Wheel Speed Proprietary
- EBC4 Wheel Brake Lining Remaining Information
- EBC5
- EEC1
- EEC2
- Engine Configuration Messages
- Engine Fluid Level/Pressure 1
- Engine Hours, Revolutions
- Engine Temperature
- ERC1-RD
- ETC1 - T
- ETC1 - CV
- ETC2
- ETC7
- Fuel Consumption
- Fuel Economy
- High Resolution Vehicle Distance
- Inlet/Exhaust Conditions
- PTO information Proprietary
- Retarder Fluids
- Supply Pressure
- TCO1
- Time/Date
- Transmisson Control 1 (TC1)
- Transmission Fluids
- Transmission Proprietary/DLN5
- Transmission Proprietary 2 - T
- Transmission Proprietary 2 - AWD
- Vehicle Weight
- Vehicle Weight
- Requirements for CAN communication with the vehicle
©
Scania CV AB 2013, Sweden
CAN interface for bodywork
Detailed description of CAN messages
11:90-01 Issue 1 en-GB 60 (139)
Not available FF
212Front axle 1
Differential lock disengaged 00
Differential lock engaged 01
Error 10
Not available 11
32Front axle 2
Differential lock disengaged 00
Differential lock engaged 01
Error 10
Not available 11
52Rear axle 1
Differential lock disengaged 00
Differential lock engaged 01
Error 10
Not available 11
72Rear axle 2
Differential lock disengaged 00
Differential lock engaged 01
Error 10
Not available 11
312Central
Differential lock disengaged 00
Differential lock engaged 01
Error 10
Not available 11
Byte Bit Length Explanation State Resolution Limits Note