User Manual
Table Of Contents
- CAN interface for bodywork
- Introduction
- Summary of CAN messages
- Detailed description of CAN messages
- Explanation
- CAN messages sent to the vehicle
- CAN messages sent from the vehicle
- Software identification
- Scania bodywork status message 1
- Air Supply Pressure
- Air Suspension Control 1
- Alarm Status Proprietary
- Ambient Conditions
- BAM-E
- Cab Illumination Message
- Cab Information Proprietary 1
- Cruise Control/Vehicle Speed
- Crash Occured
- Coordinator General Information
- Coordinator General Information 2
- CUV information
- Dash Display
- DLN2-Proprietary
- DLN5-Proprietary
- DLN8-Proprietary
- DM1
- EAC1-K
- EBC1
- EBC2 Wheel Speed Proprietary
- EBC4 Wheel Brake Lining Remaining Information
- EBC5
- EEC1
- EEC2
- Engine Configuration Messages
- Engine Fluid Level/Pressure 1
- Engine Hours, Revolutions
- Engine Temperature
- ERC1-RD
- ETC1 - T
- ETC1 - CV
- ETC2
- ETC7
- Fuel Consumption
- Fuel Economy
- High Resolution Vehicle Distance
- Inlet/Exhaust Conditions
- PTO information Proprietary
- Retarder Fluids
- Supply Pressure
- TCO1
- Time/Date
- Transmisson Control 1 (TC1)
- Transmission Fluids
- Transmission Proprietary/DLN5
- Transmission Proprietary 2 - T
- Transmission Proprietary 2 - AWD
- Vehicle Weight
- Vehicle Weight
- Requirements for CAN communication with the vehicle
©
Scania CV AB 2013, Sweden
CAN interface for bodywork
Detailed description of CAN messages
11:90-01 Issue 1 en-GB 73 (139)
Not available 1010
Not available 1011
Not available 1100
Not available 1101
Not available 1110
Not available 1111
218Drivers demand engine - percent torque 1 % -125 % to +125 %
Error indicator FEh
Not available FFh
318Actual engine - percent torque 1 % -125 % to +125 %
Error indicator FEh
Not available FFh
4116Engine speed 0.125 r/min 0 to 8 031.875 r/min
Error indicator FExxh
Not available FFxxh
618Source address of controlling device for engine
control
1 0 to 250
Error FE
Take no action FF
714Engine starter mode
Start not rqed 0000 1 0 to 15
Starter active gear not engaged 0001
Starter active gear engaged 0010
Strt fnshd strtr nt actv aftr hvng bn a 0011
Strtr inhbtd d to eng already running 0100
Strtr inhbtd d to eng nt ready for start 0101
Byte Bit Length Explanation State Resolution Limits Note