User Manual
Table Of Contents
- CAN interface for bodywork
- Introduction
- Summary of CAN messages
- Detailed description of CAN messages
- Explanation
- CAN messages sent to the vehicle
- CAN messages sent from the vehicle
- Software identification
- Scania bodywork status message 1
- Air Supply Pressure
- Air Suspension Control 1
- Alarm Status Proprietary
- Ambient Conditions
- BAM-E
- Cab Illumination Message
- Cab Information Proprietary 1
- Cruise Control/Vehicle Speed
- Crash Occured
- Coordinator General Information
- Coordinator General Information 2
- CUV information
- Dash Display
- DLN2-Proprietary
- DLN5-Proprietary
- DLN8-Proprietary
- DM1
- EAC1-K
- EBC1
- EBC2 Wheel Speed Proprietary
- EBC4 Wheel Brake Lining Remaining Information
- EBC5
- EEC1
- EEC2
- Engine Configuration Messages
- Engine Fluid Level/Pressure 1
- Engine Hours, Revolutions
- Engine Temperature
- ERC1-RD
- ETC1 - T
- ETC1 - CV
- ETC2
- ETC7
- Fuel Consumption
- Fuel Economy
- High Resolution Vehicle Distance
- Inlet/Exhaust Conditions
- PTO information Proprietary
- Retarder Fluids
- Supply Pressure
- TCO1
- Time/Date
- Transmisson Control 1 (TC1)
- Transmission Fluids
- Transmission Proprietary/DLN5
- Transmission Proprietary 2 - T
- Transmission Proprietary 2 - AWD
- Vehicle Weight
- Vehicle Weight
- Requirements for CAN communication with the vehicle
©
Scania CV AB 2013, Sweden
CAN interface for bodywork
Detailed description of CAN messages
11:90-01 Issue 1 en-GB 77 (139)
Engine Configuration Messages
Identifier: 18 EB FF 00
Transmission interval: 100 ms until the whole message is sent in one BAM cycle.
The PGN for engine configuration in J1939 is 00 FE E3.
Always sent from BWS.
Byte Bit Length Explanation State Resolution Limits Note
1116Engine speed at idle, point 1 0.125 r/min 0 to 8 031.875 r/min
Error indicator FExx
Not available FFxx
318Percent torque at idle, point 1 1 % -125 % to +125 %
Error indicator FE
Not available FE
4116Engine speed at point 2 0.125 r/min 0 to 8 031.875 r/min
Error indicator FExx
Not available FFxx
618Percent torque at point 2 1 % -125 % to +125 %
Error indicator FE
Not available FE
7116Engine speed at point 3 0.125 r/min 0 to 8 031.875 r/min
Error indicator FExx
Not available FFxx
918Percent torque at point 3 1 % -125 % to +125 %
Error indicator FE
Not available FF
10 1 16 Engine speed at point 4 0.125 r/min 0 to 8 031.875 r/min