User Manual
Table Of Contents
- CAN interface for bodywork
- Introduction
- Summary of CAN messages
- Detailed description of CAN messages
- Explanation
- CAN messages sent to the vehicle
- CAN messages sent from the vehicle
- Software identification
- Scania bodywork status message 1
- Air Supply Pressure
- Air Suspension Control 1
- Alarm Status Proprietary
- Ambient Conditions
- BAM-E
- Cab Illumination Message
- Cab Information Proprietary 1
- Cruise Control/Vehicle Speed
- Crash Occured
- Coordinator General Information
- Coordinator General Information 2
- CUV information
- Dash Display
- DLN2-Proprietary
- DLN5-Proprietary
- DLN8-Proprietary
- DM1
- EAC1-K
- EBC1
- EBC2 Wheel Speed Proprietary
- EBC4 Wheel Brake Lining Remaining Information
- EBC5
- EEC1
- EEC2
- Engine Configuration Messages
- Engine Fluid Level/Pressure 1
- Engine Hours, Revolutions
- Engine Temperature
- ERC1-RD
- ETC1 - T
- ETC1 - CV
- ETC2
- ETC7
- Fuel Consumption
- Fuel Economy
- High Resolution Vehicle Distance
- Inlet/Exhaust Conditions
- PTO information Proprietary
- Retarder Fluids
- Supply Pressure
- TCO1
- Time/Date
- Transmisson Control 1 (TC1)
- Transmission Fluids
- Transmission Proprietary/DLN5
- Transmission Proprietary 2 - T
- Transmission Proprietary 2 - AWD
- Vehicle Weight
- Vehicle Weight
- Requirements for CAN communication with the vehicle
©
Scania CV AB 2013, Sweden
CAN interface for bodywork
Detailed description of CAN messages
11:90-01 Issue 1 en-GB 87 (139)
ETC1 - T
Identifier: 0C F0 02 03
Transmission interval: 10 ms.
Note: Sent at a transmission interval of 16 ms if the vehicle is fitted with an Allison
automatic gearbox.
Only sent from BWS if the vehicle has Opticruise or an Allison automatic gearbox.
Byte Bit Length Explanation State Resolution Limits Note
112Driveline engaged
Driveline disengaged 00
Driveline engaged 01
Error indicator 10
Not available or not installed 11
32Torque converter lockup engaged A
Torque converter lockup disengaged 00
Torque converter lockup engaged 01
Reserved 10
Don’t care/take no action 11
52Shift in progress
Shift is not in progress 00
Shift in progress 01
Error indicator 10
Not avaliable or not installed 11
7..8 Not defined
2116Output shaft speed 0.125 r/min 0 to 8 031.875 r/min
Error indicator FExx