User Manual
Table Of Contents
- CAN interface for bodywork
- Introduction
- Summary of CAN messages
- Detailed description of CAN messages
- Explanation
- CAN messages sent to the vehicle
- CAN messages sent from the vehicle
- Software identification
- Scania bodywork status message 1
- Air Supply Pressure
- Air Suspension Control 1
- Alarm Status Proprietary
- Ambient Conditions
- BAM-E
- Cab Illumination Message
- Cab Information Proprietary 1
- Cruise Control/Vehicle Speed
- Crash Occured
- Coordinator General Information
- Coordinator General Information 2
- CUV information
- Dash Display
- DLN2-Proprietary
- DLN5-Proprietary
- DLN8-Proprietary
- DM1
- EAC1-K
- EBC1
- EBC2 Wheel Speed Proprietary
- EBC4 Wheel Brake Lining Remaining Information
- EBC5
- EEC1
- EEC2
- Engine Configuration Messages
- Engine Fluid Level/Pressure 1
- Engine Hours, Revolutions
- Engine Temperature
- ERC1-RD
- ETC1 - T
- ETC1 - CV
- ETC2
- ETC7
- Fuel Consumption
- Fuel Economy
- High Resolution Vehicle Distance
- Inlet/Exhaust Conditions
- PTO information Proprietary
- Retarder Fluids
- Supply Pressure
- TCO1
- Time/Date
- Transmisson Control 1 (TC1)
- Transmission Fluids
- Transmission Proprietary/DLN5
- Transmission Proprietary 2 - T
- Transmission Proprietary 2 - AWD
- Vehicle Weight
- Vehicle Weight
- Requirements for CAN communication with the vehicle
©
Scania CV AB 2013, Sweden
CAN interface for bodywork
Detailed description of CAN messages
11:90-01 Issue 1 en-GB 88 (139)
A: Only if the vehicle has an Allison automatic gearbox.
Not avaliable FFxx
418Percent clutch slip 0.4% 0 to 100%
Error FE
Not avaliable FF
512Momentary engine overspeed enable
Momentary engine overspeed is disabled 00
Momentary engine overspeed is enabled 01
Reserved 10
Take no action 11
32Progressive shift disable 0.125 r/min 0 to 8 031.875 r/min
Progressive shift is not disabled 00
Progressive shift is disabled 01
Reserved 10
Take no action 11
5..8 Not defined
6116Input shaft speed 0.125 r/min 0 to 8 031.875 r/min A
Error indicator FExx
Not avaliable FFxx
818Source address of controlling device for trans-
mission control
1 0 to 255
Error FE
Take no action FF
Byte Bit Length Explanation State Resolution Limits Note