Specifications

11
 Rotate Image: Rotates the image 90 degrees clockwise. This allows you
to control the image orientation prior to saving.
 Zoom Image: Click to enlarge the image for better reading.
 Scan Image: Starts the image scan if using manual scan and
the image source is set to scanner. Otherwise, activates the FILE OPEN
dialog.
Note: ‘Toggle to file’ is possible only if a scanner is physically connected to the PC, or if
the license key used is a temporary key.
 Toggle Image Source: Sets the input image source to
Scanner (ScanShell 800 or ScanShell 1000), Magnetic Strip, or an image file
on the hard disk.
 Scanner Connection: A green light indicates that the scanner is
connected to the PC. A red light indicates that no scanner was found.
 Delete Image: Deletes the scanned image. This gives you a
way to control the image prior to saving.
 Save to File: Active only in manual save mode: Opens the
SAVE AS dialog if file saving is enabled, or saves the file to the clipboard.
 Toggle Image Output: Active only in manual save mode: Sets the
output destination to file or clipboard.
 Card Verification: Activates the verification function.
 Toggle reference (*ScanShellOCR Only): Sets the reference
source for card verification purposes.
 Open OCR View (*ScanShellOCR Only): Opens extracted text view.
 Open Configuration Dialog: Opens the configuration dialog screen in
which all the application behavior can be set.
 Exit / End of Scan: Used to close the application or to save the current
image (used in automatic save mode only).