Instruction manual

Activating the alarm function
1. To activate the alarm function, repeatedly press the ALARM/SNOOZE button, the alarm wake-up
mode will be displayed and change in the below sequence on every press:
2. When the display shows your desired alarm wake-up mode, release the button, the alarm function is
now activated and the alarm icon will be displayed.
3. When the alarm time arrives, the selected wake-up mode will be on and the alarm icon in the display
will flash to indicate the alarm is triggered. To stop the alarm sooner, press the STANDBY/ON button.
4. To check the alarm status, press the ALARM/SNOOZE button once and the alarm status will be
displayed.
Note: If you have activated the alarm function and the wake-up mode is DAB or FM, make sure that the
alarm volume level is set at a sufficient level for you to hear.
Automatic Alarm Repeat
The alarm will automatically repeat each day at the selected time as long as the alarm icon is displayed. To
cancel this function, repeatedly press the ALARM/SNOOZE button until the display shows “Alarm Off”.
SN OOZ E FUN CTI ON
When the alarm has triggered, press the ALARM/SNOOZE button will temporary switch off the alarm for 5
minutes. A small “z” icon will appear by the side of the alarm icon to indicate snooze on. This is repeatable in
the one hour alarm duration.
SLEEP FUNCTION
This function allows you to program the radio to switch off itself after a set period of time.
1. To activate the sleep function, repeatedly press the SLEEP button, the display will show “Sleep Timer”
and the time will change in the below sequence on every press:
2. When your desired sleep time appears in the display, release the button, the sleep function will be
confirmed in two seconds. A small “s” icon will appear in the display to indicate sleep timer on. When the
sleep time counts to zero, the unit will go off.
3. To put the sleep function off, press the SLEEP button again and the “s” icon in the display will disappear.
4. To check the sleep timer status, repeatedly press the INFO button until you see the sleep timer
information appears in the display.
Note: The sleep function can be activated only in AC operation, there is no sleep function in DC operation.
HEADPHONE JACK
A 3.5mm type stereo headphone jack is located at the back of the unit. Connect a set of stereo headphones
(not included) to this jack for private listening without disturbing others. The speakers are automatically
disconnected when the headphones are in use.
IMPORTANT: When using headphones always set the volume to a low level before you put the headphones
on. Then insert the headphones and gradually increase the volume to a comfortable listening level.
SP ECI FIC ATIO N
POWER SUPPLY : AC 100-240V~60/50Hz
DC 6V 1.5V(UM2) x 4
OUTPUT POWER : 2 W x 2
FREQUENCY RANGE : DAB 174 - 240 MHz
FM 87.5 - 108 MHz
UNIT DIMENSION : 260 (L) x 102.5 (W) x 192.5 (H) mm
WEIGHT: 1.57kg
SPECIFICATION SUBJECT TO CHANGE WITHOUT FURTHER NOTICE.
Alarm Off
DAB Preset # FM Preset # Buzzer Tone #
UK-5
90 8 0 7 0 60 30 1 0
Waste electrical and electronic products must not be disposed of with household waste.
Please refer to the retailer from whom you purchased this item for disposal instructions.
Packaging materials should be recycled using local facilities.