User manual

UK-7
this radio can receive stereo music from many other Bluetooth source devices including personal computers,
PDAs, Bluetooth enabled music players. The exact connection procedures may vary from device to device,
please refer to the device user manual for specific operations.
Note: An increasing number of computing devices include support for Bluetooth, and many include support for
stereo music over Bluetooth (A2DP). For best performance from your particular device, please ensure that you
are using the latest update of software drivers and/or firmware available. In certain circumstances, updating the
software drivers or firmware of your device to the latest release may add support for A2DP that was not available
in a previous release. Please contact the vendor of your device for such updates and refer to the device user
manual for update procedures. Please remember that system updates should only be performed by qualified
individuals after performing a full system backup.
SLEEP FUNCTION
This function allows you to program the radio to switch off itself after a set period of time.
1. To activate the sleep function, repeatedly press the SLEEP button, the display will show "Sleep Timer" and the
time will change in the below sequence on every press:
2. When your desired sleep time appears in the display, release the button and the sleep function will be
activated in two seconds. The display will show "s#" where "s1" is to represent "10 minutes" sleep time and so
on.
3. When the sleep time counts to zero, the unit will go off. To put the sleep function off during sleep timer on,
repeatedly press the SLEEP button until the display shows "Sleep Timer Off".
4. To check the sleep timer status, press the SLEEP button once.
AUXINPUT
There is a 3.5mm stereo aux input socket located at the back of the unit; analogue audio sound signals from other
sources can be input to the radio through this socket.
To select AUX function, repeatedly press the MODE button until you see "Switch to AUX" is displayed, the audio
will be switched to the aux input signal and you can adjust the volume control for your desired sound output level.
Note: To further enhance energy saving, if the unit is left in AUX mode and without any user operation for three
hours, the unit will switch itself to standby automatically; To toggle select this function between on & off During
unit on, press and hold the MODE button for longer than two seconds, the display will show "ECO ON" or "ECO
OFF".
USB PORT
There is an USB port located at the back of the unit, a standard 5V/500mA output is provided for normal USB
charging capability. USB data communication is not available through this port.
DISPLAY BACKLIGHT
The backlight level is defaulted to "Low" in standby and "High" during operation. This is resumed only when the
factory reset has taken place. There are four backlight levels for you to set in unit operation.
1. To set the backlight during operation, first press the MENU button once, then rotate the SCROLL control
followed by pressing on it to enter into the "Backlight" menu.
2. In the "Backlight" menu, rotate the SCROLL control to select the backlight level - High/Medium/Low/Off.
3. In either standby or operation, the backlight will be turned on to "High" for 5 seconds on every key press.
HEADPHONE JACK
A 3.5mm type stereo headphone jack is located at the back of the unit. Connect a set of stereo headphones (not
included) to this jack for private listening without disturbing others. The speakers are automatically disconnected
when the headphones are in use.
IMPORTANT: When using headphones always set the volume to a low level before you put the headphones on.
Then insert the headphones and gradually increase the volume to a comfortable listening level.