Operation Manual

23
Hints and tips
If a problem occurs, it may often be due to something very minor. The
following table contains various tips:
Problem Solution
No power Ensure the mains cable is connected securely at both ends.
Make sure that the ON mode is selected.
The remote
control does
not function
Use the remote control near the unit.
Point the remote control at the remote sensor on the unit.
Replace the battery in the remote control with a new one.
Remove any obstacles between the remote control and the unit.
The unit does
not respond
when pressing
any buttons
The unit may freeze up during use. Switch the unit off and then on again
at he mains socket to reset the unit.
CD
The disc does
not play
There is no disc inside the unit (“No Disc” appears on the display).
Insert the disc correctly with the label side facing up.
Clean the disc.
PAUSE mode may be activated, deactivate it.
A non-valid disc has been inserted.
Condensation may have formed inside the unit due to a sudden change
in temperature. Wait about an hour for it to clear and try again.
Disc skips Make sure the unit is on a secure spot. Vibrations or jarring can cause
the disc to skip.
Radio
Desired station
not found
Weak signal. Use the Manual Tune function.
No DAB coverage in your area or poor reception.
Adjust the position of the aerial.
USB
USB port not
charging
Not all device are compatible with USB charging.
Bluetooth
I cannot nd
“BT speaker N”
my Bluetooth
device
Ensure the Bluetooth function is activated on your Bluetooth device.
general operation
powering ON/OFF
Scan Time
00:00:00” and synchronize to the current local time if you can receive a DAB signal in your
location. After approximate one minute, it will switch to STANDBY mode.
t Press on the unit or press ON/STAND-BY on the remote control to switch the unit to
ON mode.
t Press to switch the unit back to STANDBY mode.
t
completely.
t When the unit is idle for approximately 15 minutes, it will automatically switch to standby.
t
selecting modes
Press MODE repeatedly to switch between DAB, FM, CD, USB, AUX and Bluetooth modes.
adjusting the volume
t Turn the VOLUME +/– dial on the unit or press VOLUME +/– on the remote control to
adjust the volume.
t
MUTE on the remote control. Press MUTE again
or press VOLUME +/– on the remote control or turn VOLUME +/– to resume normal
listening.
auto setting the clock
The clock can be updated automatically if you can receive a DAB signal in your location.
In order to synchronise to the current local time you must leave it on the DAB station for a
short period of time.
manually setting the time
1. During Standby mode, press and hold CLOCK on the remote control. The hour digits
2. Press to adjust the hour digits, and then press CLOCK
3. Press to adjust the minute digits, and then press CLOCK
4. The time is now set.
15
MODE repeatedly on the unit or press
CD, USB, TUNER/DAB, AUDIO IN,
BLUETOOTH on the remote
If any functional abnormality is encountered, unplug the unit from
the mains socket and reconnect it again.