Manual

4
3. Installation
3.1 Unpacking
1) Take device and its accessories out of the box.
2) Remove the packing material.
3) Check the standard shipment packing list to make
sure you have received all of the items ordered.
IG-300 series
- 2D Imager Scanner
- Power Adaptor (if applied)
- Communication Cable
- User Manual
4) Visually inspect the device and accessories for any
evidence of physical damage.
5) If anything is missing or appears to be damaged,
immediately contact your dealer.
ATTENTION:
Store the packing material and boxes: it should
be used whenever the device is transported for
servicing.
3.2 Mounting
Once you have unpacked all components, you can
start installing the device as below steps:
IG-300 2D Imager Barcode Scanner
1) Connect the supplied communication cable at the
bottom side of the scanner and you will hear a
“click” when the connection is made.
2) Turn off the host system.
3) Connect the communication cable to Host system.
4) Connect the Power supply (if needed) to Power
cable inlet. And plug the power supply into the
AC outlet.
5) Turn on the host system.