Product Manual

ManualsBrandsSchaefer ManualsExhaust FansExhaust Fan — 16in., 3,085 CFM, 110/220 Volt

Polyethylene Flushmount

Exhaust Fan Series Operators Manual

IMPORTANT: READ AND SAVE THESE INSTRUCTIONS

Read all instructions carefully before attempting to assemble, install, operate or service the product described.

Failure to comply with instructions could result in personal injury and/or property damage.

Using this product for any other purpose than it was intended, or not within the operating speciﬁcations in this

manual will void the warranty and may cause damage to the fan or serious injury to personnel.

Outlet View

Polyethylene Exhaust Fan

WARNING - TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK:

t Do not expose fan to water or rain.

t The power source must conform to the electrical requirements of the fan. Consult your local electrician before wiring and

follow all national, state, and local electrical codes.

t Disconnect all power before performing maintenance.

t DO NOT use a variable speed control device, unless your fan has been equipped with a VFD-compatible motor.

GENERAL SAFETY

t This fan is intended for general use only. Do not use near hazardous or explosive materials or vapors.

t Never insert ﬁngers or any other objects into the fan when in operation.

t Use of an OSHA complying guard if within seven feet of ﬂoor is recommended.

t Use of a guard, shutter or hardware cloth if above seven feet of ﬂoor is recommended.

t Carefully read all safety messages in this manual and on your equipment safety decals.

Follow recommended precautions and safe operating practices.

Summary of content (4 pages)

PAGE 1
Polyethylene Flushmount Exhaust Fan Series Operators Manual Outlet View Polyethylene Exhaust Fan IMPORTANT: READ AND SAVE THESE INSTRUCTIONS Read all instructions carefully before attempting to assemble, install, operate or service the product described. Failure to comply with instructions could result in personal injury and/or property damage.
PAGE 2
KEEP THIS MANUAL IN A CLEAN, DRY PLACE FOR FUTURE REFERENCE. All information, illustrations and speciﬁcations in this manual are based on the latest product information available at the time of printing. Product speciﬁcations subject to change. We reserve the right to make changes at any time without notice. If you need replacement parts, please contact your dealer. Take special care when ordering replacement blades, pulleys, motors and belts to ensure you get the proper conﬁguration for your fan.
PAGE 3
POWERING THE FAN: ! CAUTION: ALL ELECTRICAL WORK SHOULD BE COMPLETED BY QUALIFIED ELECTRICIAN AND MEET ALL NATIONAL, STATE AND LOCAL CODES. INSTRUCTIONS FOR WIRING t 8JSJOH TIPVME POMZ CF EPOF CZ B USBJOFE FMFDUSJDJBO UP QSFWFOU JOKVSZ PS EFBUI t $POmHVSF JOUFSOBM XJSFT UP NBUDI TVQQMZ WPMUBHF BOE XJSF BDDPSEJOH UP NPUPS nameplate. Test to verify correct rotation. t .BOZ PG UIF FMFDUSJD NPUPST JO PVS GBOT BSF SFWFSTJCMF .
PAGE 4
TROUBLESHOOTING SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION Fan not operating 1. Improper wiring 2. Fan control set above room temperature 3. Blown fuse or tripped breaker 4. Fan blade contacting fan 5. Fan control defective .PUPS EFGFDUJWF 1. Ensure wiring is done correctly 2. Set to a lower temperature 3. Replace fuse or reset breaker 4. Realign fan blade in fan housing 5. Repair or replace control 6. Repair or replace motor Insufﬁcient airﬂow 1. Shutter jammed 2.