Self-Contained Power Mister USER'S MANUAL PVM18C PVM18 WARNING IMPORTANT SAFETY INFORMATION INSIDE • Serious injury or death is possible. • Retain these instructions for future reference. • Read, understand and follow all safety information and instructions in this manual before using or servicing this product.
Index SPECIFICATIONS ......................................................................................................................2, 3 SET-UP / OPERATION ..............................................................................................................4, 5 MAINTENANCE ............................................................................................................................6 REPLACEMENT PARTS...............................................................................
Specifications (continued) PVM18LC • One 18" fan head with powder-coated guard mounted on a yoke attached to the pump enclosure. • An integral ground fault circuit interruptor (GFCI) is attached to the power cord. • Equipped with a power cutoff tip switch. • Includes one extra nozzle and two plugs. • Shipped in a single carton, ready to assemble on your existing 10 gallon Igloo cooler. PVM18 • One 18" fan head with powder-coated guard mounted on a yoke attached to the pump enclosure.
Set-Up / Operation 1. 2. 3. 4. 5. 6. 7. Always operate the power mister on a level surface. In the event the unit is tipped over or tilted more than 35 degrees, a built-in tip switch will shut off power to the pump and fan. Power will be restored when unit is returned to the upright position. Fill cooler or tank with clean, fresh water (ice may be added) each time the mister is used. Drain remaining water after each use. Aim the mister downwind for best results.
Set-Up / Operation (continued) CAUTION • • • • • Never operate pump without water supply. If leaks are observed, turn pump off and tighten fittings by hand. Excessively hard water (high solids) can plug nozzles. A plugged filter caused by poor water quality can restrict flow to pump and cause permanent damage. Never allow "fog" from the nozzles to come in contact with surfaces. This can cause condensation and water will form on those surfaces; redirect the fan to prevent this circumstance.
Maintenance NOZZLES WARNING The fog or spray pattern exiting from the nozzles should have an even cone shape. If this is not the case, the nozzle should be cleaned or replaced. Nozzle function should be checked regularly to assure best misting and evaporation performance. ELECTRICAL SHOCK HAZARD • Serious injury or death is possible. To clean or replace a nozzle: 1. Disconnect the unit from electrical supply. 2. Unscrew and remove the nozzle. 3.
Warranty Schaefer Ventilation Equipment, LLC Schaefer Limited Warranty Policy Schaefer Ventilation Equipment, LLC (SVE) provides the following limited warranty from the date of invoice to the initial purchaser of our products or to its customer with a dated proof of purchase: I. Two-year coverage (unless otherwise indicated below) applies to all products, components and assemblies provided by SVE that prove to be defective in material or workmanship.
00-779-3267 www.schaeferfan.